Contour lines, in the grain.
I'm Mark. As an intelligence analyst in the Marine Corps, I spent years reading terrain maps. At home in my woodshop, I kept noticing the same thing: wood grain looks like contour lines.
It still hangs at home.
One weekend years ago, I built my first terrain light to test the idea. It still hangs in our home, and it's the piece guests always ask about.
After the Marines, I studied computer science and wrote my own software to turn hand-drawn lines into precise cut paths. Every piece starts with me tracing the grain of its own sheet of plywood, so no two are alike. A CNC machine makes the cuts, and I sand, finish and assemble each one by hand.
Each one is accounted for.
Each light is signed and numbered by hand. The number on the piece is the number on its page here.
Proof on the piece.
Every light is authenticated through a QR code that is only visible on the piece itself, for its buyer.
The wood draws its own map.
Plywood is made of thin layers of wood. Where the top layer was sliced through the tree's growth rings, it shows long wandering lines, like the contours on a map. A piece follows those lines and nothing else.
- 01
One sheet
Every piece begins as a single sheet of plywood, photographed flat. Its figure is already a landscape, if you know how to read it.
- 02
Its own lines
The grain is traced line by line. Those lines, and only those, become the cuts. Nothing is drawn on top of the wood.
- 03
Cut apart
A CNC router follows each line through the sheet. What was one board is now a set of pieces that only fit one way.
- 04
Raised and lit
Each piece is lifted to its own height on steel bolts over a backing board, and light is set behind it.
The design is already in the sheet.
No pattern is laid over the wood. The sheet is photographed flat, and the lines of its figure are traced across it, edge to edge. Those lines become the cuts.
Because the lines belong to that one sheet, the pieces they make belong to it too. Another sheet gives another landscape. That is why each piece here is made once and sold once.
The cut pieces are then lifted to different heights. Broad pieces sit low, like plains; small enclosed ones rise, like peaks. Seen from the side it is a relief; seen straight on, the shadows draw the map.
Lit from behind.
Lights sit in the backing board, behind the raised pieces. You never see a bulb, only what it does: a warm wash on the board, and bright seams where the cuts let it through.
Raised on steel.
Every piece stands on hex bolts through the backing board. A nut under the piece sets its height, a nut on top holds it. The number of bolts grows with the weight, so none carries more than it should.
It arrives flat, and is built by hand.
- A kit, not a crate. The pieces, the backing board, the bolts and nuts, with a guide written for that exact piece.
- Everything is labelled. Each hole in the board carries the same tag as the bolt that goes through it.
- Into the studs. The backing board hangs on screws driven into wall studs. The guide gives the weight and how many.
- Care is dusting. A soft dry brush between the pieces. Keep it out of damp rooms and direct weather.